JDSU NT850 Betriebsanweisung PDF herunterladen (Seite 82)

Chapter 6 Interpreting Test Results

Status and Error Messages for Network Tests

66 LanScaperPRO Network Tester User’s Guide

Status and Error Messages for Network Tests

DHCP Request

In the ping test with DHCP on, the LanScaperPRO

displays this message on the first status line while it is

trying to get the required information from a DHCP server.

The DHCP request is repeated every 10 seconds when a

response is not received, and the count is shown on the

same line as the status.

Find Active Link

The tester is searching for incoming link pulses while

waiting to start an active test. Hub Flash, Cisco Discovery,

and Ping test modes need to be connected to an active

network in order to run. In those modes, this status

appears while the tester is searching both the 1-2 and 3-

6 pairs for incoming Ethernet Link pulses.

Link Found

Status displayed while searching for link pulses after an

incoming signal has been detected.

Link Not Found

Status displayed while searching for link pulses and

nothing has been detected.

LanScaperPRO_User_Guide.book Page 66 Friday, January 25, 2008 1:14 PM

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 105 106

Keine Kommentare

JDSU NT850 Betriebsanweisung Seite 82