
Chapter 3 Performing Network Tests
Performing PoE Tests
36 LanScaperPRO Network Tester User’s Guide
4 Press the SEL key.
5 Press the TEST key to connect to the Ethernet port
and capture the CDP information.
Once a CDP packet is collected, the messages are
displayed, along with headings for each of the fields
in the message, as in Figure 14.
Figure 14 The CDP Display Screen, post-test
6 Use the up and down arrow keys to scroll through the
information.
7 Repeat steps 5 and 6 as needed.
8 Press the QUIT key to exit Cisco Discovery mode.
Performing PoE Tests
The Power over Ethernet (PoE) test identifies what
power-providing equipment, if any, is connected to the
other end of the jack or cable being tested.
To perform a PoE test
1 Connect a patch cable to the unknown jack or
connect the cable plug directly to the tester.
LanScaperPRO_User_Guide.book Page 36 Friday, January 25, 2008 1:14 PM
Kommentare zu diesen Handbüchern