JDSU TP300 Betriebsanweisung PDF herunterladen (Seite 15)

To Place Tone on a Cable

Connect cable to be traced to a main

unit jack. For best signal, do not

connect a remote to the other end.

Due to the shielding effect of twisted

pairs, the strongest signal is obtained

by having one wire of a pair carry tone.

Selecting a single pin instead of a pair

will do this. For coax, the Tone is best

applied to the shield and the shield

cannot be grounded.

Turn on Resi-Tester™ by pressing the

button associated with the connector

to be used followed by pressing the

TONE button. Short presses of the

TONE button will select a different pin.

Holding down the TONE button for more

than 2 seconds will select a different

tone pattern.

To turn Resi-Tester™ off, press any

button except TONE. The tone will turn

off automatically after about 2.4 hours.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Keine Kommentare

JDSU TP300 Betriebsanweisung Seite 15