JDSU TP500 Betriebsanweisung PDF herunterladen (Seite 7)

Instructions for Use

LanRoamer

™

powers off automatically after

5 minutes of continuously testing a cable.

Disconnecting the cable restores normal

function. Be sure to install a battery if using for

the first time—see battery installation.

To Test a Patch Cable

1) Plug one end of patch cable into main unit.

2) Plug other end of cable into remote unit.

3) The tester will power on immediately,

indicating a test in progress by quickly

winking the pair lights on both the main

and remote; it will then be followed by a

combination of pair lights on — this shows

the test results. See Main Unit Results and

Remote Unit Results sections on page 7.

4) Disconnect patch cable after test. The test

repeats automatically every 2.3 seconds if

the cable has only open and passing pairs

and repeats every 4 seconds if there are

failures.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

JDSU TP500 Betriebsanweisung Seite 7